PRODUCT BULLETIN: CETM-40/2200e, Temperature Test Chamber for Steering Wheels

Environmental tests allow the simulation of different components of a vehicle at different temperatures. For vehicle horn, these tests must be performed under the strictest tests of durability over time, where a mechanical part simulates the pressure that a hand would perform during a long period of time in some few days. The thermal test chamber will be responsible for simulating the temperatures that the horn will suffer both in cold and in heat, even in the most extreme conditions. The chamber should be integrated with the test bench both mechanically (design) and in software so that the operation of both elements together.

The thermal test chamber, CETM-40/2200e is prepared to condition 3 steering wheels with the mechanical elements at the same time. It has 3 independent shelves to be able to extract each steering wheel individually in a comfortable, fast and simple way. Its cold group is located on a separate bench, to minimize the heat and noise emitted by it. Its control will communicate with the control of the mechanical actuator to be able to coordinate both controls in a synergistic manner.

If you want more information, please contact us in comercial@dycometal.com or in our website: www.dycometal.com

DYCOMETAL, company with over 25 years of experience in the development of Chambers for environmental testing simulation, offers its customers TEMPERATURE CHAMBER FOR STEERING WHEEL to do these tests.

PRODUCT BULLETIN: THERMAL SHOCK CHAMBER AIR TO LIQUID, CRT2VT-25

The AIR to LIQUID thermal shock chamber subjects the test samples to greater stress. The chamber has a double compartment, in the upper zone the air is conditioned at a certain temperature and in the lower area there is a thermostated bath of controlled temperature, between + 2ºC and + 5ºC. The pieces will move through a basket between both compartments suffering the stress process, simulating splash conditions, dives, etc. The sample will move between both compartments to verify that it does not suffer any fracture, crack or apparent damage.

The thermal shock chamber, CRT2VT-25 has been designed for the production process (R&D), so that the most extreme conditions that the samples can supported are analysed. The samples will be tested in the hot zone and go down to the water bath, if the sample doesn’t suffer any damage, then the temperature of the heating zone will be increased and repeat again the operation until the samples suffer a damage.

If you want more information, please contact us in comercial@dycometal.com or in our website: www.dycometal.com 

DYCOMETAL, company with over 25 years of experience in the development of Chambers for environmental testing simulation, offers its customers thermal shock chambers air to liquid.

PRODUCT BULLETIN; CET/AFA-0/100/174, DOUBLE TEMPERATURE TEST CHAMBER (CHAMBER + OVEN)

All objects that surround us must be tested under environmental conditions of temperature or humidity, to ensure reliability in storage, transport or operation. More; in sensitive elements such as weapons ammunition, which must be tested both in the laboratory and in the field, to ensure that it does not suffer deterioration under the most extreme environmental conditions.

The temperature test chamber, CET/AFA-0/100/174 is a chamber that allows conditioning the samples in the field or in the laboratory without distinction. Its compact design occupies little space and facilitates the transport of equipment to the field inside a truck or van. Its interior space, is optimized to the maximum to condition the largest number of samples.

If you want more information, please contact us in comercial@dycometal.com or in our website: www.dycometal.com

DYCOMETAL, company with over 25 years of experience in the development of Chambers for environmental testing simulation, offers its customers chamber for conditioning of ammunition.